Home / Applications
Seven sectors, seven different pore requirements. For each one: the problem, the grade we start from, the sizing numbers that matter.
Taste and odour compounds, geosmin, MIB, pesticides and residual chlorine are present at concentrations the treatment train can barely measure and consumers notice immediately. The fix is contact time and the right micropore volume, not a bigger dose.
Coconut carbon keeps its hardness through repeated backwash, so the bed survives to adsorption exhaustion. Utilities switching from coal should expect a shorter first cycle while the bed stabilises and fines wash out.
After biological treatment, what remains is the fraction biology cannot eat: refractory organics, colour bodies, surfactants and trace solvents. Carbon polishing is usually the last barrier before discharge or reuse — and the first process blamed when a permit limit is missed.
Coal gives the mesopore volume that colour bodies need. Where COD load fluctuates seasonally, pair a fixed GAC bed with PAC dosing for peaks instead of sizing the bed for the worst week of the year.
In carbon-in-pulp and carbon-in-leach circuits, carbon is both the adsorbent and a mechanical component. It has to load gold fast, survive tumbling in a slurry, and come out of the kiln intact after elution.
Hardness is the number that decides cost per ounce. A carbon at 97% hardness loses less to attrition per cycle, which shows up in the elution balance rather than on the purchase order.
Sugar, starch, edible oil, gelatin and spirits all carry colour and off-flavour bodies that come out of the process. Decolourisation is a mesopore problem measured in molasses number, not iodine value.
Ask for molasses number and a jar test on your actual liquor. Iodine value alone will over-specify micropore capacity you cannot use on a large colour molecule.
API purification, decolourisation and pyrogen removal demand carbon with controlled extractables, low ash and a documented wash step. The specification has to survive an audit, not just a bench trial.
Low-ash, low-extractable grades with batch-level documentation are available. Provide the pharmacopoeia reference and we quote against it with the corresponding test data.
Solvent recovery, paint booth emissions, biogas upgrading and sewage odour all hinge on pressure drop and working capacity. The wrong format costs more in fan energy than in carbon.
For H₂S and mercaptans, move to impregnated grades — KI or KOH. Physical adsorption alone saturates quickly and then releases the load on the next swing.
Long-chain PFAS are adsorbable on GAC, but bed life is short and the design margin is thin. Under-sizing a contactor here is expensive to correct, because the fix is more empty bed contact time — steel, not media.
Treat GAC as one barrier in a train, not the whole solution. We model breakthrough against your inlet concentration so the change-out interval is planned rather than discovered.
Contaminant, inlet level, flow rate, target limit — four numbers are enough for a first recommendation and a media volume estimate.